Free SCP Network Performance Monitor (NPM) Exam SCP-NPM Exam Practice Test

Your network has critical devices on the opposite side of a WAN link from you SolarWinds server. You do not want alerts about the devices if the router (name = “target”) that connects your SolarWinds server to the remote site is down. How do you configure Alert Suppression?

• Suppress alert when all of the following apply: Node Name is equal to “target” / Interface Status is equal to “Warning”
• Suppress alert when any of the following apply: Node Name is equal to “target” / Node Status is equal to “Warning”
• Suppress alert when any of the following apply: Node Name is equal to “target” / Interface Status is equal to “Down”
• Suppress alert when all of the following apply: Node Name is equal to “target” / Node Status is equal ta “Down”

Your team member cannot see any reports in the Orion Console. What can cause this issue?

• The reports are configured with more than one limitation category
• The No Reports limitation is applied to the user account
• The SQL server is on a different system than the SolarWinds server
• The Report Writer is not installed

You configure an alert to send you an email when you have a high CPU load on your devices. Your NPM web console shows several devices have high CPU utilization, but you have not received any emails. What could be the issue?

• The alert threshold is set too high
• The hardware resources assigned to the system are too low
• The alerts are muted on the devices
• SNMP is not configured on the devices

What can you use to retrieve a single value in SNMP? (Choose all that apply.)

• GET VALUE
• GET NEXT
• GET TABLE
• GET

How do you assign users access to select reports?

• Create the reports while logged in as each user and set permissions
• Use custom properties and account limitations to control report access
• Configure the report and add a Report Limitation. Assign the limitation to users who need access to the report
• Save the reports in different sub-directories and set the permissions for each user

You can use Device Studio to create pollers for CPU and memory?

• TRUE
• FALSE

You created a Universal Device Poller (UnDP) but cannot find an OID in the MIB tree. How do you resolve this issue?

• Restart the Universal Device Poller
• Update the MIB database
• Rediscover the node via Network Sonar Discovery
• Add the node to NPM for monitoring

What is required of your nodes to detect duplex mismatches? (Choose all that apply.)

• Duplex of both devices must be identified as full or half
• Ensure corresponding values for each interface are different
• The nodes must support topology and be interconnected
• Unify the duplex mode configuration on neighboring interfaces