Free Fortinet NSE 5 – FortiManager 6.4 Exam NSE5_FMG-6.4 Exam Practice Test

An administrator with the Super_User profile is unable to log in to FortiManager because of an authentication failure message.Which troubleshooting step should you take to resolve the issue?

• Make sure FortiManager Access is enabled in the administrator profile
• Make sure Offline Mode is disabled
• Make sure the administrator IP address is part of the trusted hosts.
• Make sure ADOMs are enabled and the administrator has access to the Global ADOM

Which two conditions trigger FortiManager to create a new revision history? (Choose two.)

• When configuration revision is reverted to previous revision in the revision history
• When FortiManager installs device-level changes to a managed device
• When FortiManager is auto-updated with configuration changes made directly on a managed device
• When changes to device-level database is made on FortiManager

Which two statements regarding device management on FortiManager are true? (Choose two.)

• FortiGate devices in HA cluster devices are counted as a single device.
• FortiGate in transparent mode configurations are not counted toward the device count on FortiManager.
• FortiGate devices in an HA cluster that has five VDOMs are counted as five separate devices.
• The maximum number of managed devices for each ADOM is 500.

An administrator would like to create an SD-WAN default static route for a newly created SD-WAN using the FortiManager GUI. Both port1 and port2 are part of the SD-WAN member interfaces.Which interface must the administrator select in the static route device drop-down list?

• port2
• virtual-wan-link
• port1
• auto-discovery

An administrator would like to create an SD-WAN using central management in the Training ADOM.To create an SD-WAN using central management, which two steps must be completed? (Choose two.)

• Specify a gateway address when you create a default SD-WAN static route
• Enable SD-WAN central management in the Training ADOM
• Configure and install the SD-WAN firewall policy and SD-WAN static route before installing the SD-WAN template settings
• Remove all the interface references such as routes or policies that will be a part of SD-WAN member interfaces

An administrator would like to create an SD-WAN using central management. What steps does theadministrator need to perform to create an SD-WAN using central management?

• First create an SD-WAN firewall policy, add member interfaces to the SD-WAN template and create a static route
• You must specify a gateway address when you create a default static route
• Remove all the interface references such as routes or policies
• Enable SD-WAN central management in the ADOM, add member interfaces, create a static route and SDWAN firewall policies.

What does a policy package status of Conflict indicate?

• The policy package reports inconsistencies and conflicts during a Policy Consistency Check.
• The policy package does not have a FortiGate as the installation target.
• The policy package configuration has been changed on both FortiManager and the managed device independently.
• The policy configuration has never been imported after a device was registered on FortiManager.

Which of the following statements are true regarding schedule backup of FortiManager? (Choose two.)

• Backs up all devices and the FortiGuard database.
• Does not back up firmware images saved on FortiManager
• Supports FTP, SCP, and SFTP
• Can be configured from the CLI and GUI

An administrator has added all the devices in a Security Fabric group to FortiManager.How does the administrator identify the root FortiGate?

• By a dollar symbol ($) at the end of the device name
• By an at symbol (@) at the end of the device name
• By a
• By an Asterisk (*) at the end of the device name

An administrator has enabled Service Access on FortiManager.What is the purpose of Service Access on the FortiManager interface?

• Allows FortiManager to download IPS packages
• Allows FortiManager to respond to request for FortiGuard services from FortiGate devices
• Allows FortiManager to run real-time debugs on the managed devices
• Allows FortiManager to automatically configure a default route