Free NetApp Accredited Hardware Support Engineer Exam NS0-093 Exam Practice Test

When you plan an ONTAP upgrade, which NetApp tool generates a detailed upgrade plan?

• ONTAP System Manager
• Active IQ Unified Manager
• Upgrade Advisor
• Active IQ Config Avisor

You have upgraded your cluster from ONTAP 9.5 software to ONTAP 9.7 software. After two days, you notice that the upgrade is causing issues. You decide to revert to ONTAP 9.5 software.Which two actions do you need to complete before you revert? (Choose two.)

• Revert from ONTAP 9.7 software to ONTAP 9.6 software and then to ONTAP 9.5 software.
• Delete all Snapshot copies from the past two days.
• Reinstall your boot media and install ONTAP 9.5 software.
• Wipe your config and restore from backup.

A node has failed.Which two conditions must be met for an automatic takeover to be triggered? (Choose two.)

• The combined utilization of both nodes must be less than 100%.
• The cluster network must be available.
• Mailbox disks must be reachable.
• NVRAM must be synchronized.

Which two scenarios are common causes of the root volume needing root volume recovery? (Choose two.)

• The root volume ran out of space.
• The mainboard was replaced following a Non-Maskable Interrupt (NMI) panic.
• Root volume migrate was performed.
• The cluster configuration is out of sync on the volume.

What are two valid commands that can be used to trigger an AutoSupport? (Choose two.)

• ::> autosupport history show-upload-details –node
• ::> system node coredump upload –node
• ::> autosupport invoke –node –type all
• ::> autosupport invoke-core-upload –node

You have replaced a failed boot device. You perform boot_recovery and receive no errors. However, when the node reboots, it reports that it has no disks.What are two possible causes? (Choose two.)

• The SAS cables were incorrectly reconnected after reinstalling the motherboard.
• The disks that are owned by this node have been marked as failed.
• The node is booting a lower version of ONTAP software than was last used.
• The interconnect is down.

In which two sections of AutoSupport can you find information to analyze the following panic? (Choose two.)Panic_Message: PCI Error NMI from device(s):ErrSrcID(CorrSrc(0xf00),UCorrSrc(0x18)), RPT(0,3,0):Qlogic FC 16G adapter in slot 1 on Controller

• HA-RASTRACE.TGZ
• ALL-COREDUMP.XML
• SSRAM-LOG
• PCI-HIERARCHY.XML

What should be the first step taken after detecting a NetApp WAFL inconsistency?

• Run wafliron.
• Stabilize the system.
• Force ofline the affected aggregate.
• Run a dump to null.

What are two options to remove Failure Byte on disks that are marked as failed? (Choose two.)

• Power cycle the disk shelf.
• Reseat the disk.
• Update the disk firmware.
• Unfail the disk

Which command can you use to confirm successful completion of an ONTAP upgrade?

• system controller sp upgrade show
• cluster image show-update-progress
• job show –jobtype upgrade
• system node upgrade-revert upgrade-task –node –version