Free HP Aruba Certified Switching Associate Exam HPE6-A72 Exam Practice Test

Which network category applies to a SOHO internal network?

• SD-WAN
  
• LAN
  
• WAN
  
• Internet
  

What is the Link Layer Discovery Protocol?

• a discovery protocol used between Layer 3 devices to determine routes within a single autonomous system
  
• a standardized IPv6 neighbor discovery protocol used to replace the ARP and broadcast mechanism used in IPv4
  
• a standardized protocol for communicating directly-connected device information and capabilities.
  
• an Aruba proprietary discovery protocol supported in all Aruba switches along with Cisco Discovery Protocol or CDP
  

Core(config)# user admin passwordCore(config)# interface mgmtCore(config-if-mgmt)# ip static 10.254.16.89/22Core(config-if-mgmt)# default-gateway 10.254.19.129Core(config)# ssh server vrf mgmtCore(config)# https-server vrf mgmtYou are tasked with configuring the Core switch to be managed by NetEdit. Currently, the Core switch is at factory-default settings.Which two steps are missing? (Choose two.)

• Core(config)# https-server rest access-mode read-write
  
• Core(config-if-mgmt)# no shutdown
  
• Core(config-if-mgmt)# no tftp-server
  
• Core(config-if-mgmt)# enable
  
• Core(config)# https-server rest access-mode read-only
  

Which option correctly describes a WAN network?

• a group of computer resources that communicates between geographically separate location
  
• the connection between two separate buildings in the same campus
  
• a network of devices over long distances but limited to within a single ISP
  
• compute resources that are networked locally over wireless
  

Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)

• write memory
  
• save
  
• copy config config1 config startup-config
  
• copy running-config startup-config
  
• copy running-config checkpoint boot-config
  

Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)

• Aruba 6405
  
• Aruba 2930F
  
• Aruba 8400
  
• Aruba 5406R
  
• Aruba 8350
  

Interface 1/1/1 is upAdmin state is upLink transitions: 1Description: TO_PC-1Hardware: Ethernet, MAC Address: 00:11:22:33:44:55MTU 1500Type 1GbTFull-duplexqos trust noneSpeed 1000 Mb/sAuto-negotiation is onFlow-control: offError-control: offMDI mode: MDIXVLAN Mode: accessAccess VLAN: 1111Which command will produce the above output?

• show interface vlan 1111
  
• show interface 1/1/1
  
• show interface gigabit 1/1/1
  
• show vlan 1111
  

What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?

• backup secondary sftp://admin@10.1.1.21/GL.10.04.0003.swi
  
• copy secondary sftp://admin@10.1.1.21/GL.10.04.0003.swi
  
• copy sftp://admin@10.1.1.21/GL.10.04.0003.swi secondary
  
• copy secondary tftp://admin@10.1.1.21/GL.10.04.0003.swi
  

What is true about VSX? (Choose two.)

• VSX is ideal for Campus access layer deployments where ease of deployment is needed.
  
• VSX allows upgrading members with near zero downtime or loss of packets.
  
• VSX is available on all Aruba OS-CX switches except the 6300F model.
  
• VSX is implemented on static port switches. VSX-plus needed to stack chassis together.
  
• VSX run separate control planes to reduce latency and improve performance.
  

ServiceOS login: adminSVOS> passwordEnter password: ********Confirm password: ********The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above.What is the default password that is required for the admin account while under the Service OS console?

• No password is set for this account.
  
• 'password'
  
• 'forgetme!'
  
• The same login password that has lost originally.