Free Specialist Implementation Engineer SC Series DES-1721 Exam Practice Test

What is the maximum number of drives that can be supported on an SC9000 storage array?

• 948
• 960
• 1024
• 1048

A customer is using an SC8000 array with three chained SC220 expansion enclosures on a single card. They need to expand its capacity by adding an SC280 enclosure. How should the new expansion enclosure be connected using a minimum number of chains?

• Add the SC280 to the same chain as the existing SC220 enclosures
• SC280 enclosures cannot be mixed with other enclosures
• Install a new SAS I/O card to connect the SC280 enclosure
• Add the SC280 to a new chain on the same SAS I/O card

Why would the Key Management Server (KMS) Settings page appear during installation?

• Page appears only if SED drives are present
• Page only appears if an external KMS is defined during setup and configuration
• Page is standard and always appears as part of the installation and configuration
• Page only appears if a security certificate is not generated

After an initial implementation of a SC Fibre Channel front-end, during the failover test one of the controllers gets reset. All Virtual WWNs from the reset controller are migrated to a single port of the remaining controller.What corrective action should be taken?

• Check cabling, FC Zoning or Fault Domains for incorrect configuration and revise as needed
• Incorrect cables used, re-cable as needed
• This is the expected behavior and the test completed successfully
• FC zoning is not enabled, enable zone config

What is used for migrating data from legacy system volumes to SC default provisioned volumes?

• Thin Import
• Intelligent Import
• Thick Import
• Live Migration

Which feature is included on SC9000 storage arrays?

• SED/FIPS Secure Data
• Data Reduction
• Data Progression
• Asynchronous Replication

How many SC220 enclosures can be supported by an SC4020 storage array?

• 7
• 9
• 14
• 15

What is the recommended minimum number of ports per controller, per fault domain, to support port-level failover?

• 1
• 2
• 3
• 4

What is the HDD size that enforces dual redundancy?

• 2 TB and higher
• Up to 3 TB
• 4 TB and higher
• 3 TB and higher

You need to set up the iDRAC IP address on an SC Series controller with the following details:*IP address 192.168.0.160*subnet mask 255.255.255.0*gateway 192.168.0.1Which commands should be used to complete this task?

• ifconfig inet set eth0 ip 192.168.0.160ifconfig inet set eth0 netmask 255.255.255.0ifconfig inet set eth0 gateway 192.168.0.1
• ifconfig inet set eth1 ip 192.168.0.160ifconfig inet set eth1 netmask 255.255.255.0ifconfig inet set eth1 gateway 192.168.0.1
• controller ipconfig set eth0 ip 192.168.0.160controller ipconfig set eth0 netmask 255.255.255.0controller ipconfig set eth0 gateway 192.168.0.1
• platform bmc set ip 192.168.0.160platform bmc set netmask 255.255.255.0platform bmc set gateway 192.168.0.1