Free Dell RecoverPoint Operate Achievement Exam D-RP-OE-A-24 Exam Practice Test

A storage administrator has created a new Consistency Group with a remote copy. After enabling the new group, the administrator notices several otherConsistency Groups are experiencing high load alerts. What is possible cause for the high load conditions?

• Initialization is consuming all the WAN bandwidth
• Journal pool for the new Consistency Group is undersized
• Journal pool for the new Consistency Group has poor performing storage
• Not enough licensed replication storage is available for the new Consistency Group

Which RecoverPoint CLI command can be used to show a summarization of the errors and warnings for either one site or the entire RecoverPoint system?

• get_rpa_states
• get_system_status
• get_events_log
• get_clusters_topology

A RecoverPoint administrator is using the CLI to create a new Consistency Group. After beginning the process by running the command create_group, what is the nextcommand that needs to be run?

• add_replication_volume
• add_group_set
• create_replication_volume
• create_production_copy

What is the recommended wait period before running the Balance Load tool?

• 4 Days
• 5 Days
• 7 Days
• 6 Days

A storage administrator has seen high-load events in their RecoverPoint environment. The administrator wants to review the performance data for the past week withRecoverPoint. In addition, the administrator wants the raw data saved to a spreadsheet to review and create graphs of system performance over a period of time.Which CLI command should be used?

• export_statistics
• balance_load
• get_rpa_statistics
• detect_bottlenecks

Which Consistency Group setting is directly affected by the maximum Journal lag setting?

• RTO
• Deduplication
• RPO
• Compression

Which tools are listed under "System Analysis and Tools" section of Unisphere for RecoverPoint?

• Detect Bottlenecks, Balance Load, Collect System Information
• Detect Bottlenecks, Balance Load, Configure System Reports and Alerts
• Users and Security, Configure System Reports and Alerts, Change Security Level
• Users and Security, Configure System Reports and Alerts, Collect System Information

To determine whether physical or virtual RPAs are in use on a specific cluster, what is a correct sequence of steps to determine the type of RPAs for that cluster when usingUnisphere?

• Click on Protection > Cluster name > RPA details
• Click on Admin > System Analysis Tools > RPAs
• Click on RPA clusters > Cluster name > RPAs
• Click on Dashboard > RPAs > RPA type

What is the result of configuring the I/O throttling level to "low"?

• Limit the data parallelism and I/O parallelism of all RPAs in a RecoverPoint cluster to a maximum read rate of 200 MB/s
• Limit the data parallelism and I/O parallelism of all RPAs in a RecoverPoint cluster to a maximum read rate of 10 MB/s
• Limit the data parallelism and I/O parallelism on the particular RPA where the setting will permit a maximum read rate of 10 MB/s
• Limit the data parallelism and I/O parallelism on the particular RPA where the setting will permit a maximum read rate of 200 MB/s

In Unisphere for RecoverPoint, which system analysis tool can verify that Consistency Groups are replicating efficiently or provide recommendations if user action is required?

• Detect Bottlenecks
• Collect System Information
• System Notifications
• Balance Load