Free Dell PowerStore Maintenance Achievement Exam D-PST-MN-A-24 Exam Practice Test

What is the maximum number of expansion enclosures that a single Dell EMC PowerStore 9000T appliance supports?

• 8
• 3
• 4
• 2

A Storage Administrator needs to connect through SSH to run svc commands. How is the SSH session configured?

• NAS server IP address using port 22
• Appliance IP address using port 26
• NAS server IP address using port 26
• Appliance IP address using port 22

Which component is an FRU?

• DIMMs
• Embedded IO Module
• Nodes
• Battery Backup Unit

Through which network do external hosts connect to the cluster for data access?

• Storage
• Management
• Service
• Internal

What is the protocol used for the storage network?

• NFS
• FC
• iSCSI
• SMB

Which network traffic is encrypted using IPsec?

• Management network
• Service network
• Internal network
• Storage network

A Storage Administrator has an existing single appliance Dell EMC PowerStore 3000T cluster. An additional PowerStore 9000T has been purchased to add into the existing cluster.How does the administrator proceed?

• Add the new 9000T appliance into the cluster per the procedure; mixed models of the same type are supported
• Additional VLT links on the ToR switching must be configured for the 9000T to support the increased inter-switch network load
• The new appliance cannot be added to the cluster; appliance model and type must match when clustering appliances together
• Remove two of the four NVMe NVRAM drives from the 9000T; the caching configuration of all clustered appliances must match

While on-site installing a Dell EMC PowerStore T system, the node A embedded module management Ethernet port link LED is off. What does this indicate?

• Port speed is 10 GB/s
• Network connection is established
• Port speed is 1 GB/S
• No network connection is established

Under which condition does the Dell EMC PowerStore equipment in the rack require additional stability?

• Unstable humidity
• When shipping the system
• Low temperatures
• High temperatures

How can the PUHC health check results be viewed?

• From syslog server
• In Details of Appliances and Nodes
• From management DB
• By accessing the Swagger UI