Free Check Point Certified Maestro Expert Exam 156-835 Exam Practice Test

There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would be proportion oftraffic distribution done by Orchestrator?

• 66%/33%
• 100%/0%
• 50%/50%
• 33%/66%

Orchestrator should be defined in SmartConsole as:

• Orchestrator is not defined in SmartConsole
• Check Point host
• Security Gateway
• Host

What is the Sync network on Appliances used for?

• May be used for any purpose, but synchronization always have priority
• To synchronize configurations and connections in between connection tables of different Appliances
• To transfer configuration files from Orchestrators to Appliances
• To transfer data in case of full utilization of the downlink interfaces

Which setting is required in order to connect an appliance with 40Gbps downlink interface and DAC to the Orchestrator MHO-140?

• On Orchestrator: Change QSFP mode from 100Gbps to 40Gbps
• On Orchestrator: Change port type from uplink to downlink
• On Appliance: Change a port speed to 10Gbps
• No change required

Which is a valid requirement for a supported Maestro appliance?

• 10GBps and 40Gbps or 100Gbps card with double-VLAN and LLDP support
• At least one 10GBps line card
• Nothing special as Maestro supports any Check Point appliance
• Line card with double-VLAN and LLDP support

What is a Security Group?

• Logical group of computer and network resources
• Group of security administrators
• Group of security gateways
• Group of appliances with enabled NGTX software blades

What does the lldpctl command do?

• Show all devices discovered by LLDP protocol on downlink ports
• Discover orchestrators
• Show all devices discovered by LLDP protocol on uplink ports
• Show all devices discovered by LLDP protocol on all ports

Where should sx_api_ports_dump,py command be ran?

• Orchestrator
• SMO Appliance
• Management server
• Security Group

What is the default range of physical ports for downlinks on Orchestrator MHO-170?

• 3 - 16
• 17 - 31
• 25 - 32
• 1 - 16

What is the purpose of g_tcpdump command?

• Collects traffic dump from Sync network
• The same as tcpdump, just on Scalable Platform
• Collects traffic dump from CIN network
• Collects traffic dump from all Active Appliances within Security Group