Free Supporting Cisco Routing & Switching Network Devices 100-490 Exam Practice Test

Which two commands set the configuration register value? (Choose two.)

• rommon>confreg 0x2102
• router(config)#confreg 0x2102
• rommon>config-register 0x2102
• router(config)#configuration-register 0x2102
• router(config)#config-register 0x2102

What are the choices for modes of operation when deploying Cisco Catalyst 3850 Series switches?

• Active mode and Standby mode
• Install mode and Bundle mode
• Boot mode and Run mode
• Exec mode and User mode

Which set of steps best describes how to assign a static IP address to the Ethernet port on a computer?

• From the Network and Sharing Center, click Internet Protocol (TCP/IP), and follow the New Connection Wizard instructions.
• From the Network and Sharing Center, click Change adapter, then double-click a local area connection. Select Internet Protocol (TCP/IP) > Properties > Use the Following Address, and then configure the IP information.
• Click Start. Enter cmd and click OK. Enter the IP address XXX.XXX.XXX.XXX.
• From the Network and Sharing Center, double-click Local Area Connection. Select Properties > iPass Protocol (IEEE 802.1x) > Properties > Static IP.

Which Xmodem option is used to enhance error checking of an image that is copied to flash memory?

• -e
• -r
• -c
• -x

Which command shows the status of power supplies and sensor temperatures?

• show hardware
• show module
• show environment
• show diag

Which bits represent the boot field in the configuration register value?

• highest two bits
• lowest two bits
• highest four bits
• lowest four bits

Which two sets of pins are looped on an RJ-45 56K loopback plug? (Choose two.)

• pins 1 and 4
• pins 1 and 7
• pins 2 and 5
• pins 2 and 7
• pins 2 and 8

Which command sends an echo request packet to the target host and then waits for an echo response message?

• echo
• access
• ping
• connect

What does Cisco use for Return Materials Authorization tracking of field-replaceable parts?

• product number
• serial number
• RMA number
• FRU number

Which command displays a list of file systems that are available on Cisco devices?

• show memory
• show directory
• show file system
• show version